Just had another thought check that the temp sender is wired correctly as this can cause the fan to stay on.
Category Archives: Engine & Drivetrain
Build Session #22 – Start Up!
First off we removed the tape from the LH cycle wing to wire up the indicator repeater, which was exactly the same process as with the right hand one. Continue reading Build Session #22 – Start Up!
Email #14
Hello John,
No, this part has been filled as well.
Kind regards
Hi Derek
Tony was very helpful on the replacement wing and it arrived this week.
One quick question: I know you said the gearbox had already been filled, but I notice in the Start Up chapter it mentions putting 300ml of oil into the gear-lever hole. Would we need to do this?
Regards
John
Parts Delivery #9
Jubilee clip for the air box pipe arrived today…
Email #12
Hello John,
I’ll send one out today.
Kind regards Continue reading Email #12
Build Session #17 Boot Trim
Slightly later start today, due to catching up with Carl and it being my birthday. One of my presents was a Dremel multitool, which would come in very handy later on. My sister also made me a fantastic Caterham cake… Continue reading Build Session #17 Boot Trim
Build Session #15 Finishing the rear
We only had one day’s work planned this weekend, but as the missing damper unit bolts had now arrived we were aiming to complete the rear suspension as a minimum. Continue reading Build Session #15 Finishing the rear
Parts Delivery #7
Parts Delivery #6
New, longer throttle cable arrived today…
Email #8
Hi Derek
The manual says that a non-LSD diff should not need oil, but ours has a sticker saying “NO OIL” your diff will need to be filled up, all the doffs now come without oil.
Either way I’d like to check it before we go much further. Is is a case of filling until oil comes out of the filler hole? Yes
Regards
John