Just had another thought check that the temp sender is wired correctly as this can cause the fan to stay on.
You need to make the union on the caliper earth out, you could try a centre punch on the edge of the copper washer and caliper to see if the works. Continue reading Email #16
The connecter is for a 12v socket if you want it fitted between the seats; there is one also under the dash.
The repeater is an earth issue check the brake line fitting as the light earths through this.
Kind regards Continue reading Email #15
No, this part has been filled as well.
Tony was very helpful on the replacement wing and it arrived this week.
One quick question: I know you said the gearbox had already been filled, but I notice in the Start Up chapter it mentions putting 300ml of oil into the gear-lever hole. Would we need to do this?
I’ll send one out today.
Kind regards Continue reading Email #12
I managed to sort the handbrake.
Hadn’t wound the cable back anywhere near enough!!
I will send out the parts, make sure the lever is down and it is clipped in correctly. We only do one cable and we don’t ever have any problems with it.
Continue reading Email #10
I will get the correct cable sent out. In the factory we no longer fit under seat carpet.
Kind regards Continue reading Email #9
The manual says that a non-LSD diff should not need oil, but ours has a sticker saying “NO OIL” your diff will need to be filled up, all the doffs now come without oil.
Either way I’d like to check it before we go much further. Is is a case of filling until oil comes out of the filler hole? Yes
I will send out the breather bottle as this engine was built before we did away with the bottle.
Kind regards Continue reading Email #6